Articles

Sphero Flex - Clinical Procedure

Product Information |

Clinical Procedure |

Laboratory Procedure |

Videos and Documents |

Product Specifications |

Screw in the attachment with the proper cuff height.  Tighten the screw as much as necessary. Unscrew and tighten again. Perform this operation 3 or 4 times to obtain a good fit.

Insert the directional rings under the spheres and then try in the appropriate retnetive cap.

Before processing it is advisable to remove the rentetive cap and insert a protective disk over the sphere and then replace the retnentive cap.

Try the prosthesis in the mouth and check if the spaces are large enough. Fill the holes with self-curing resin and position the prosthesis in the mouth.

When the resin has hardened, remove the protective disk and then remove any excess resin.

The finished prosthesis.

You are here: Home

 Share on:

Headquarters

Via E. Zago, 10 - 40128 Bologna
Tel. +39 051244510
Fax +39 051 245238

USA Branch

www.rhein83usa.com