Designed for multiple-position applications on milled and threaded CAD/CAM overdenture bars. These titanium attachments feature a TiN coating that increases surface hardness to 1,600 Vickers.
• Internal Hex Design
• Normo Sphere (Hex 1,3mm)
• Low Profile
• Simple Maintenance
• Individual Hex Drivers Available
• 1 SINGLE THREADED SPHERE NORMAL SIZE + TiN (HEX 1.3mm THREAD 2mm)
Kit contains:
• 1 STAINLESS STEEL HOUSING
• 1 PROCESSING CAP / BLACK (for laboratory)
• 4 RETENTIVE CAPS (1 green, 1 yellow, 1 pink, 1 clear)
• 1 PROTECTIVE DISK
• 6 SILVER CAPS NORMAL SIZE (EXTRA-RESILIENT)
(elastic and gummy – 350g)
• 6 GOLD CAPS NORMAL SIZE (EXTRA-RESILIENT)
(slightly elastic – 500g)
Ref. 049PCN• 6 GREEN CAPS NORMAL SIZE
(very elastic retention – 350g)
• 6 YELLOW CAPS NORMAL SIZE
(extra soft retention – 500g)
• 6 PINK CAPS NORMAL SIZE
(soft retention – 900g)
• 6 CLEAR CAPS NORMAL SIZE
(standard retention – 1300g)
• 2 TITAN CAPS NORMAL SIZE
• 6 BLACK CAPS NORMAL SIZE
(for laboratory use only)
• 2 STAINLESS STEEL HOUSINGS NORMAL SIZE
• 2 TITANIUM HOUSINGS NORMAL SIZE
• 1 HEX DRIVER FOR THREADED SPHERE NORMAL (HEX 1,27mm)
• 1 EXTRACTOR/INSERTER TOOL FOR CAPS (normal and micro sizes – for the insertion of the caps inside the metal housings)
Once the bar has been connected with wax, create an area where the attachment spacer will be placed.
Apply separator to the base of the attachment spacer and position it using the parallelometer key.
With the attachment spacer in position, complete the wax-up design.
Carefully remove the attachment spacers and proceed with the normal casting procedure.
Screw the threaded attachment of choice (micro Ball shown) into the threaded sleeve.
Place the assembled attachment into the parallelometer key. Use a self curing metal to metal bonding composite on the sleeve and in the cylinder.
After the composite is cured, remove any excess material.
Unscrew the attachment to verify if the threaded sleeve is securely bonded in place.
The finished bar complete with attachments.
